DLSC-F Series Thermal Imaging System

Item

DLSC-F337

DLSC-F642

Detector

Type

Uncooled FPA

Resolution

384*288

640*480

Imaging

Performance

FOV/Min Focal Length

12°×9°/0.5m

15°×11°/1m

Spatial Resolution

0.67mrad

0.41mrad

NETD

≤0.06℃@30℃

Frame Rate

50/60Hz

Focus

Manual / Automatic Electrical Focus

Spectral Range

8~14μm

Visible camera

Zoom

20 /30 Optical Zoom

Resolution

1080P

Min Illumination

0.005（Lux）

PTZ

Horizontal rotation angle

0°～360°Continuous rotation

Preset Position

MAX 255, Angle Feedback Support

Mounting & Pitching Angle   

Top Mounting, -90°～+90°

Measurement

Range

-20℃~+650℃

Accuracy

±2℃ or ±2% of reading (whichever is greater)

Correction

Manual / Automatic

Mode

Free Setting in Software

Storage

Raw Image

Raw images real-time transfer via client control software, the images are analyzable and measureable

Storage Format

H.264 real-time recording

Single Frame Image capture in JPG format

Power

External Power

220AC

Power Consumption

≤75W(25℃ nominal)

Environment

Operating Temp

-40℃~+65℃

Protection Class

IP54

Humidity

≤90% (Non-condensing)

Automatic identification management

Automatically identify the heat map acquired by the system, and identify valid target of the heat map through image registration to ensure the efficiency of temperature detection.

Anti-false alarm identification System

All temperature measurements are based on valid target recognition. According to the inspection strategy, measure only marked devices, and automatically eliminate disruptive heat source, effectively preventing false alarms.

Detailed equipment work status management

Establish a management system for all equipment and components, during automatic cruising, perform temperature analysis and record of all equipment components within the scope of inspection of the infrared camera, specific to detailed equipment failure location.

Automatic cruise

Preset PTZs can be used to set up more than 128 regular check positions, provide multiple modes of auto-cruise programs, realizing fully automatic operation, equipment working status inspection several times a day, automatic warnings, automatic report output. Reduce the number of on-site visits, and improving the efficiency of operators.

Automatic warning

During system cruising, it will automatically alarm if abnormal temperature are found on the target device, the alarm information includes text messages and sound messages, informing the operator for specific information of the alarm location, in order to track the fault point, confirm the alarm condition and eliminate the fault.

Automatically generate reports

System software can automatically generate device temperature analysis report for a single frame of infrared image, or comprehensive report. The system can automatically record the temperature value of each temperature measurement, and generate a temperature report to reflect the temp changes of the contact point in a certain period of time.

Infrared panorama

Provides wide field of view, high accuracy, 360 degree full view infrared image

Front-end temperature measurement method

Front-end temperature measurement, directly output the temperature data without computer processing, and the temperature signal is directly superimposed on the video signal

Dual-field surveillance, assisted identification

The infrared camera and the high-magnification visible light camera are mounted on the same head,  not only ensure that the two cameras monitor the same position, but also solve the problem that the infrared thermal image is difficult to identify device installation position, convenient for instantly checking of the hot spots of equipment

Low network bandwidth

Supports low-bandwidth operation mode, occupy bandwidth less than 0.8M under the condition of guaranteeing transmission of temperature data and image data at the same time.

Development kit

Instrument real-time control development kit

Image Processing Development Kit

Infrared image transformation equipment intelligent identification development kit

Client Remote Control Development Kit

Client Web Remote Control Development Kit

Development Support Response

Instant response, 24-hour on-site support, full Chinese support

Universal protocol support

Direct support for IEC60870-5-104 protocol

Direct support for IEC61850 protocol